Enter your dump-body length, rear overhang, expected load, and desired dump angle. The selector compares active Primary Mover telescopic models using the current product ranges and published manual capacity chart.
Your dump-body setup
Use the total length that rises with the cylinder.
Odd or custom lengths require technical verification because the manual chart uses standard body lengths.
Measure from the rear hinge pivot to the rear edge of the moving body.
For 12–24 in, the selector uses the next-lower published chart point as a conservative screen. Other values require technical review.
Include the body, tailgate, liner, tarp hardware, side extensions, and everything else raised.
Choose the package after the hoist model is selected. Hoist Only is for a customer-supplied compatible power unit. The Standard Kit includes the 12V power unit. The Extreme Series adds the 24V high-flow performance package and can reduce dump time by roughly half. Package choice does not change the published lifting capacity or dump angle.
Preliminary Recommendation
Enter your setup above
The selector will compare body-length fit, published dump angle, and capacity.
Required gross lifted load—
Published capacity at 2,800 PSI—
Published max dump angle—
Complete the fields and select “Find My Telescopic Kit.”
Installation requirements apply to every telescopic hoist and every load: Properly size and reinforce the lower H-frame support, upper cylinder mounting area, structural cross-members or subframe, rear hinge supports, and moving dump body. The upper mounting brackets must be fully supported, laterally restrained, welded, and gusseted as required by the current manual so they cannot walk outward, spread apart, or bend outward under load; welding only across the rear of the brackets is not adequate. Correct cylinder location, welding, alignment, hydraulic setup, reinforcement, and load distribution are critical. Improper support or installation can cause distortion or structural failure even when the published lifting calculation clears.
Published table values are based on current Primary Mover model-specific charts and approximately 2,800 PSI. Lower hydraulic pressure reduces available lifting force; do not expect the published capacity from a lower-pressure system. Never exceed the pressure limit stated in the current manual or model-specific documentation. Exact chart points are 12, 18, and 24 inches of rear overhang. For a custom overhang between those points, the selector uses the next-lower published reference as a conservative preliminary screen and requires final geometry verification.
Important preliminary-use notice: This selector is designed exclusively for current Prime Force telescopic hoists sold by Primary Mover and should not be used to size or evaluate another manufacturer’s equipment. It assists with product selection only and is not a certified vehicle, trailer, fabrication, structural, or legal load rating. Never exceed the lowest applicable GVWR, GAWR, chassis, axle, tire, wheel, hitch, coupler, dump-body, hinge, hoist, cylinder, hydraulic-system, or other component rating. Published capacity values assume approximately 2,800 PSI and an evenly distributed load. Lower pressure reduces lifting capacity; never raise system pressure above the current manual or model-specific limit to compensate. Concentrated, frozen, shifting, or uneven loads can substantially increase stress. Final selection, cylinder location, mounting support, reinforcement, welding, load distribution, and hydraulic compatibility must be verified by qualified personnel using the current product manual.
